Shipping across CanadaSupport: Mon-Fri 9AM-6PM
GeoBrakes stocks a complete range of passive and active ABS wheel speed sensors confirmed to fit the Toyota Crown, each sourced to OEM specifications for direct-fit installation and reliable ABS performance on your Crown. Every Toyota Crown sensor is compatible with traction control and stability control systems.
Your Toyota Crown ABS wheel speed sensor is the component that makes anti-lock braking possible on your Crown. It monitors the rotational speed of each wheel in real time and sends that data to the Toyota Crown ABS control module, which uses it to prevent wheel lockup during emergency stops. When a sensor fails on your Crown, your ABS loses the input it needs. On wet, icy, or gravel road surfaces, the difference between a controlled stop and a skid can come down to whether your Toyota Crown wheel speed data is reaching the module.
The ABS wheel speed sensor on the Toyota Crown is an electromagnetic or Hall-effect sensor mounted near each wheel hub or bearing assembly of your Crown. It generates an electronic signal as a toothed reluctor ring rotates past it, producing a frequency the Crown ABS module interprets as wheel speed. On most modern Toyota Crown vehicles, this same data feeds the traction control system, electronic stability control, and electronic brake force distribution, making a functioning wheel speed sensor critical to the safe operation of multiple Crown systems simultaneously.
GeoBrakes stocks both passive and active ABS wheel speed sensors for the Toyota Crown. Passive sensors use an analog signal and are found on older Crown vehicles and many trucks still in service. Active Hall-effect sensors require a small power supply and output a clean digital signal, offering greater accuracy at very low speeds. Active sensors are standard on most Toyota Crown vehicles manufactured after the mid-2000s and are required for full compatibility with modern Crown traction and stability control systems.
Signal accuracy matters as much as fitment with Toyota Crown wheel speed sensors. A sensor that generates the correct frequency for your Crown ABS module ensures consistent ABS calibration, proper traction control thresholds, and accurate stability control response on your Toyota Crown. Every sensor in the GeoBrakes catalogue is matched to the Toyota Crown through our vehicle selector, with front and rear positions listed separately to eliminate position errors on your Crown.
Can I drive my Toyota Crown with a faulty ABS wheel speed sensor?
You can drive the Toyota Crown with a failed ABS sensor, but the anti-lock braking system on your Crown will be completely disabled. On icy or wet Canadian roads, this significantly increases stopping distances and the risk of losing steering control during hard braking on your Toyota Crown. Replacing a failed sensor promptly is strongly recommended, particularly before winter.
How do I find the right ABS sensor for my Toyota Crown?
Use the GeoBrakes vehicle selector and enter the Toyota Crown year, make, and model. The system displays only the sensors confirmed to fit the Toyota Crown, with front and rear positions listed separately. Select the position matching the sensor you are replacing on your Crown to avoid receiving the wrong unit.
Do I need to replace all four ABS sensors on my Toyota Crown at the same time?
No. ABS wheel speed sensors on the Toyota Crown are independent components and only the failed unit needs to be replaced. However, if your Crown has high mileage and one sensor has failed, it is worth visually inspecting the connectors on the other Toyota Crown sensors for corrosion while the wheel is removed.